There is something fishy with the cell towers by Jim Stone


Beyond a doubt, the cell towers in America are NOT what we have been told they are.

A reader sent me this: . . . . .“Jim, Years ago I owned a telecommunication and underground utilities construction company, and many of the contracts involved bringing electricity, fiber optics, etc to underground bases in Arizona, Nevada, New Mexico, California, and Texas.

I had to go through a lot of background investigations and sign documents saying I would not divulge where I “my company” was bringing these utilities to.

My company also erected many cell towers, and I always wondered why they had us bring so much electrical power to these cell towers.

Later, the Army Corps of Engineers would install frequency amplifiers connected with HXXrp. (editor’s note, HXXrp is a communications protocol I heard about at the NSA. I tried googling it to no avail, all that comes up is coincidence hits.) I believe they can control the weather. Also, all of us have a frequency pattern we emit and these cell and wifi towers can interfere with those frequencies.” . . . . .

I can just visualize Physicist bob, rolling his eyes as he read that about the cell towers affecting people. After all, Cell towers operate in the Ghz range, and clearly the brain cannot interface with THAT high of a frequency. But to that end, Physicist Bob is a lot like idiot Joe.

 

How a Ghz signal can be used to interface directly with the brain

All frequencies have a penetration depth, and typically, in water, you will hit 100 percent attenuation at one half wavelength. For a 1 GHZ signal, this will be approximately 7 inches. Most people will write that when microwaves hit water they turn into heat. But there is another step, that description is too simplistic. In reality, when any electromagnetic wave gets absorbed into a conductive medium, it does so by turning into electricity, which shorts itself out in the conductive medium, and the resulting current flow is what causes the heating. A radio antenna is tuned to approximate the frequency that is most expected and therefore rather than short out within itself, it passes the frequencies to the tuner amplifier.

So now we know how an electric current can be induced into the brain via a 1 GHZ radio signal, which will fully absorb at a depth of approximately 7 inches. Obviously then, higher frequencies with shorter wavelengths can be used, because you do not need 7 inches of penetration depth. For practical application, the frequency range is between 500 MHZ and 3 GHZ.

We have not yet answered the question of how such a high frequency can interface with the brain. It cannot. However, there are different types of modulation you can put on a wave form, and the two most common are AM and FM. For the purpose of interfacing with the brain, we will be discussing AM.

Amplitude modulation involves the use of a fixed frequency wave form called a carrier, which has its intensity increased and decreased. An amplitude modulated wave form appears to change it’s height on an oscilloscope while maintaining it’s frequency. If you have a very low frequency AM modulation on a high frequency carrier you can watch the amplitude of the carrier go to max on an oscilloscope, and then drop, all the way to flatline before returning to maximum if the modulation is strong enough and the modulating frequency is low enough to not just look like a blur.

So earlier, I established how you can use a radio wave to deliver electricity. Now, take that ghz wave form from a cell tower, which will penetrate approximately seven inches into the skull and put unintelligible high frequency electricity there, and modulate that unintelligible frequency with an ELF frequency the brain can interface with. Bam – o, you get cell phone tower induced mind control. And it’s a piece of cake, it works better than any other method, you see,

If you transmit an ELF wave form by itself, it will need a many miles long antenna to pick it up properly, it will not interface with the body very well because your body is not a big enough antenna for the ELF wave to efficiently “short out” in. You would need a really intense signal to do anything. But if you can take that ELF frequency and use it to modulate a super high frequency carrier, that carrier will drop all of it’s energy directly into your skull, and let the modulation of that energy do the rest. Of course, there are other factors, like a single side or asymmetric carrier, but to avoid getting too complex I have said enough here to give you the idea and certainly enough to put an evil genius on the right path.

The following video shows this being done to some test monkeys a little way in. Obviously in this case, the power levels are very high. Unfortunately the video has a bit of a crazy aspect to it, and it is very outdated, which is to be expected with anything of this nature that is actually allowed to stay online.

 

 

Now onto WHY ON EARTH American cell towers have so much juice going to them.

This is a serious topic.

In America, computer wifi is limited to 20 milliwatts transmit power and often even with that tiny amount you can connect from hundreds of feet away with no special antennas or hardware. Your cell phone can transmit 300 milliwatts. That’s well over 10 times the power, and the range of your cell phone is that much better. All that is needed to make a great cellular node is a 10 watt transmitter (to make sure it gets real good penetration into the surrounding buildings,) and a receiver that is more sensitive than the one in your cell phone because you are talking back with a lot less than 10 watts.

10 watts is 500 times as strong as your wireless N router that comes in perfect everywhere. A lucky neighbor might snag your unsecured router with only 20 milliwatts of output from over a block away with just a cheap netbook. Why then, since 10 watts will clearly do the job, are there these ENORMOUS out in the open giant goose invading “cell towers” in America that are obviously capable of pumping many thousands of watts?

It’s because the cell towers in America have a totally different purpose than stated. Sure, the tower does indeed accomplish the job of supporting cell phone service, but it is not needed at all for that purpose. They are there to hide something clandestine right in the great wide open.

My reader stated: “My company also erected many cell towers, and I always wondered why they had us bring so much electrical power to these cell towers.” He NAILED IT. As a technical type, I paid attention to the cell towers, and noticed that they always seem to have a 400KVA or bigger transformer feeding them (I never actually walked up and looked at the data plate). 400KVA is approximately 400,000 watts. And I never really thought about it, why on earth they always got fed so much juice. Sometimes you just need to wake up and start thinking. Mexico confirms this – cell technology is totally passe’ and a perfectly functional legitimate node can be stuck in a yard decoration powered by less juice than needed by an average Ipod dock.

Another comment came in stating that American cell towers in fact only get anywhere from twenty thousand to sixty thousand watts, complete with verified documentation that that is “all it is”. Ok, Fine then. WLS in Chicago broadcasts with 50,000 watts, and with a good radio you can hear it anywhere in the world when conditions are right. To sometimes pump even more than that into a single American neighborhood via the local tower which is serving only a two mile area is far beyond suspicious. It is case proven. Those cell towers ARE NOT WHAT WE HAVE BEEN TOLD and I am certain that even 60,000 watts would be a conservative estimate for many of them.

Why pump so many watts?

The antenna arrays on the cell towers are highly directional. That’s obvious. So since the signal from them is confined to a zone, rather than going out omnidirectionally, whatever is in that zone will get extremely high R.F. levels. Maybe you need that much for mind control, but I seriously doubt it. With such an ability to confine the signal to within a zone, I would expect a mind control beam to not need more than a couple thousand watts. Where is the rest of that power going?

My guess, is Japan, Hurricane Katrina, or Chiapas Mexico. Whatever earthquake or disaster “they” need to accomplish a political objective. And there is something you need to know about radio wave propagation – it can be steered. So just because a cell tower appears to only be able place all it’s RF output within a confined zone, it does not mean that signal cannot be diverted and sent elsewhere. This is because a neighboring cell tower can be synchronized in such a way that it steers the output from surrounding towers to a new remote area. And that is how Haarp works, BET ON IT.

American cell towers then, I believe in this order, have multiple purposes. The first is EMF mind control. Ever wonder why on some mornings EVERYONE seems to be happy, and on others EVERYONE seems to be grouchy? People don’t just naturally fall into a mold like that, yet you see it all the time. And you never used to. This is a new phenomenon. Back in the 70′s and 80′s moods were totally random. Not anymore. There are happy days when everyone is happy, and grouchy days and indifferent days. If you have not noticed this, start paying attention. People’s lives are random, and there should be absolutely no reason for their moods to all be similar for any reason other than outside manipulation. The second purpose is an occasional one – I believe that occasionally the towers will be switched up to full output to eat a nuclear reactor in Japan via a phony earthquake scenario, or to make good and sure a hurricane is useful for a social experiment in New Orleans. But you cannot have them humming away at full output all the time without it becoming obvious, so the ability is likely saved for special occasions. Furthermore, with as many as there are around, it probably does not take more than a few percent of them at any one time to pull off something big. And this is exactly why, as my reader also stated, “Later, the Army Corps of Engineers would install frequency amplifiers connected with HXXrp. I believe they can control the weather.” Why, pray tell, would the Corps of Engineers show up and install something in a “civilian” cell tower? Think about that. We all know the “elite” can trigger earthquakes. We all know they can tweak the weather. The question is then, since there is no GIANT UFO in the sky doing it, where is their system located?

And the third purpose is B.S. – “cell phone service”. That’s as close as it can get to a lie, because any telephone pole, attic, or yard decoration would do the job as well. Mexico PROVES IT.

I also received the comment: “how do the elite prevent themselves from getting beamed”? That answer is easy. The elite live in tight little enclaves that are pretty much set apart from the rest of society. Keeping the happy ray off them is as easy as simply not having the local cell tower deliver it to their isolated little pocket. To find out where YOU can live and get away from it all, pick up the phone book and move RIGHT TO THE CENTER of where all the synagogues are, that is, IF you can get in there. If you are not one of “them”, count on paying a price 4x higher than the community average. Their communities are insanely expensive for outsiders, and yet even the poorest one of them can not only live there, but get ahead while doing so.

 

Audio noise modulation, and “poppers”

During the Iraq war, America seized control of all the Iraqi transmitters, and started broadcasting propaganda. Normally, people would reject it outright. But America knew this, so under every broadcast they put a layer of noise. They did nothing to the audio people listened to, but they modulated the background noise prevalent in any radio signal (and in these broadcasts the injected noise was higher than usual, but not extreme,) and to get the Iraqis to accept what was being broadcast, even though often it was an obvious lie, the injected noise in the radio signal was modulated with a waveform that put people’s brains into a mode of acceptance, and it worked spectacularly well.

But that was not enough to satisfy American desire, so,

they dropped AM modulated microwave transmitters called “poppers” onto the rooftops and into various areas where they were not likely to be discovered. Soldiers were usually put in place to guard them. If the “poppers” were discovered, and anyone tried to de-activate them they would be shot. These worked even better than the noise modulated radio signal, and the Iraqis, who had never been exposed to such manipulation knew something was up and absolutely hated them. They figured out that the “poppers” emitted a mind control beam. But after long enough exposure, because they would be killed if they messed with the devices, they eventually succumbed and complied.

So I have covered here three different ways frequencies can be used to manipulate the mind. The first is through the manipulation of a video signal. The second is manipulation of an audio signal, and the third, and worst, is to beam it straight into your head. And the psychological warfare is extremely cruel surrounding this as well. “tinfoil hat” has been used as a phrase to designate “crazies”. Let me ask you, WHY?. “they are beaming me, and putting thoughts in my head” has been used to define “crazy”. Let me ask you WHY? I will tell you why, and it is because uncovering any great conspiracy HAS TO BE DEFINED AS “CRAZY” or the game is up. As long as people who know the truth are successfully designated as whack jobs, the truth will remain in an isolated pocket and reality will then successfully smash everyone who is deemed “sane”.

I am sure a few people will respond, saying that cell tower frequencies have a limited range. This is bogus – it is common for microwave frequencies to link at distances over 50 miles. That’s a lot more than what is needed for mind control beams, when the nearest cell tower is usually less than 2 miles away.

And I can easily see that the antennas on these cell towers are not limited to high frequencies alone. Their size is suspicious, and all it would take is a coil of wire inside one of those arrays to drop the transmit frequency WAY DOWN, into a more effective range for weather modification and other nasties, and the antenna would not need to be physically large at all.

For reference, the longest possible antenna needed for ANY cell activity in the U.S. is around 20 inches, for the lowest possible cell related frequencies. More common would be 9 inch antennas. Why then are the antennas which adorn cell towers up to eight feet long? you can easily make a high powered coil antenna suitable for low MHZ frequencies with that much room to work with. Perhaps you should ask the Corps of Engineers why the size of the arrays does not match the stated function, because the Corps of Engineers has no legitimate business on a civilian tower yet is prevalent everywhere according to one of my readers who worked with this stuff and happened to know the name of a military protocol only an insider would know. ____________________________________

http://www.jimstonefreelance.com/cells.html

About these ads

3 comments on “There is something fishy with the cell towers by Jim Stone

  1. Pingback: Mind control via electronic manipulation – by Jim Stone | 2012: What's the 'real' truth?

  2. All I can say is that am I ever glad to have gotten this post via email. I live in Southern Ontario. I grew up on a dairy and horse farm. One day I was I was driving across the country side I noticed all these new towers that had been erected. What I couldn’t understand was why were they so close to one another? I could just feel it in my bones that there was a reason for this and we the citizens were not to know. Not to mention all the times I would pick up my cell phone and it would say “NETWORK LOST” Made no sense, with all these new towers. Coming across this article gave me a sense of relief. Relief that I’m not being paranoid. I came across a youtube video about “Tower Busters” Thanks for the post ~ sending my love near and far ~

Leave a Reply

Please log in using one of these methods to post your comment:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s